The procedure is the same for fitting to both old and new tanks.
For Tank with pre-drilled
30/32mm hole
- Remove the cap from the hole
and insert transmitter, ensuring
the weather seal is securely in
- Ensure the transmitter is vertical
on top of the tank
-Tighten on to the tank using the 2 stainless steel 19mm long self –
tapping screws supplied. Do not use longer screws. Do not over
For a Tank without a predrilled hole
If a tank is not predrilled, then using a 30/32mm hole saw, drill a
hole in the top of tank in suitable area to allow ease of fitting the
transmitter and in an area that the transmitter can see the tanks
contents. Position so that there are no internal obstructions.
(i.e. ribs, stays, side of tank, internal equipment) that might
interfere with the ultrasonic signal. Ensure the transmitter is a
minimum of 10cm from any tank wall or edge.
Use the Install Help diagram to insure suitable fitting.
Ensure the transmitter is vertical on top of the tank.
Tighten on to the tank using the 2 stainless steel 19mm long
self – tapping screws supplied. Do not use longer screws. Do
not over tighten. You have now completed the installation.
Tank Height
Settings in up
Our app is now available on Google Play
